If either is incorrect, it can lead to slippage. In addition, check that you’re using the right type and size of drive rolls for your wire. If all your parameters are correct, it may just be time to change your drive rolls. If all looks well, make sure the feed settings are still set properly and the wire is within spec. Find helpful customer reviews and review ratings for Speedway Series 7117 125 Amp 110 Volt Single Phase Wire Feed Flux Welder at. If you notice you’re having to tighten your drive rolls more than before, check for damage or wear. Continue to increase the tension until you’re one-half turn past wire slippage. Loosen the drive rolls, then increase the tension while feeding the wire into a block of wood or metal.
It’s not an exact science, but here are some pro tips to help you get close: Too much tension can cause wear on the wire and too little can lead to birdnesting, so it’s important to find the sweet spot on both parts. Your welding wire not feeding properly off the spool is likely due to incorrect tension on either the spool break, the drive rolls, or both. Once you’re in the habit, it will save you time and money in the long run. You’ll also need to either blow out or replace your liner (more on that later.) Maintaining your wire in between jobs is as easy as taking it out of the welder and putting it under a blanket or in a garbage bag. If you do see rust, you can try and unspool until you find clean wire. Moisture or disuse for long periods of time can cause rust, which in turn will clog up your liner. Here’s where to start.įirst, take a look at the wire itself. And because wire-feed issues can happen anywhere along the length of the gun, you may need to check several areas until you find the problem. With a wire feed speed control of 0-400 IPM and a clamp cable length of 10 feet. wire with a thickness of 18-gauge to 3/16 in. The single phase, 115-volt welder operates at 10 at 90-Amps, uses 0.035 in. Trouble with your MIG wire not feeding properly can lead to a variety of frustrating problems that lead to downtime, extra cost, and all the associated headaches that come with having to stop what you’re doing and troubleshoot. The Speedway 90-Amp Flux Welder will help you finish all of your around the home welding jobs quickly and efficiently.